Slate Roof Flashing and Valley Repair in Hillsboro

Typical cost in Hillsboro

  • One chimney, new copper flashing$1,000 – $3,000+
  • One valley, about 15 to 25 ft long$1,500 – $5,000+
  • Several valleys and a chimney together$5,000 – $15,000+

When a slate roof leaks beside a chimney, at a dormer or where two slopes meet, the metal is the first place we look. We repair flashing and valleys on Hillsboro slate roofs, lifting the slates in the way and setting them back. A leak at one of these spots does not by itself mean the whole roof is worn out.

We serve Hillsboro first. For a leak in Beaverton, Cornelius or North Plains, give us the address and we will check that we cover it and can reach the roof.

Blue-gray natural slate surrounding a brick chimney with weathered copper flashing and a copper-lined valley.

Slate roof junction repair options

We look at the leaking joint together with the slate and walls around it before deciding how much to renew.

Slate roof with a copper valley where two roof slopes meet

Chimney flashing repairs

Slate, metal and masonry all meet at a chimney, so water can get in somewhere other than the roof surface you can see. We inspect the whole joint and the state of the chimney around it. Our quote separates flashing work from any masonry or flue repair. Reaching the flashing may mean lifting good slates; we explain how we handle them and how many matched replacements we allow for.

Valley metal renewal

A valley carries water from two slopes, and its metal can wear at a different rate from the slate beside it. Tell us how much of the valley is affected and where it drains at the bottom. Renewing it can mean lifting and refitting the slates on both sides. We spell out the metal, the roof work next to it and how we would deal with any hidden deck damage.

Gray-green slate roof with two gabled dormers and a matching lower roof over a side wing.

Dormer and wall connections

The sides of a dormer and the places where a roof meets a wall pack several short pieces of flashing into a tight space. We review them with the slate and wall finish next to them, especially where earlier repairs added sealant or surface patches. A repair that lasts gets down to the layers underneath instead of assuming the visible edge is the only problem. Putting back any wall cladding or trim we disturb is part of the work.

Find the cause before choosing the repair

Water can run along the roof before it shows inside, so the ceiling stain is only where we start looking. Note the weather each time it leaks and any earlier work in that area. We explain which detail failed and which parts are still sound. New metal and fasteners have to suit the slate already there, and a roof coating is no substitute for replacing worn metal. Send photos taken safely from the ground, and we decide how to get a closer look. If slates need replacing too, we match them. Patterned or historic roofs may need a restoration survey first.

Get a quote for your slate roof flashing and valley repair project

Indoor photos of the leak, any inspection report, past flashing repairs, the address and any known historic designation give us a place to start.

Request a free quote

View contact details

Call (971) 256-9144

Get a quote for your project

Call (971) 256-9144